Aruba HPE 2530 24G PoE+ Switch J9773A

Aruba HPE 2530 24G PoE+ Switch J9773A

Aruba HPE 2530 24G PoE+ Switch J9773A

  • 24 RJ-45 autosensing 10/100/1000 PoE+ ports (IEEE 802.3 type 10BASE-T, IEEE 802.3u type 100BASE-TX, IEEE 802.3ab type 1000BASE-T, IEEE 802.3at PoE+)

  • Media type: Auto-MDIX

  • Duplex: 10BASE-T/100BASE-TX: Half or full

  • 1000BASE-T: Full only

$460.00

Aruba HPE 2530 24G PoE+ Switch J9773A

Aruba 2530 Series Gigabit Ethernet devices are enterprise-class, fully managed, Layer 2 edge switches delivering cost-effective, reliable, and secure connectivity for business networks. Designed for entry-level to midsize enterprise networks, these Gigabit Ethernet switches provide whole Layer 2 capabilities with enhanced access security, traffic prioritization, IPv6 host support, and optional PoE+. Aruba HPE 2530 24G PoE+ Switch J9773A model has 24 x 10/100/1000 PoE-enabled ports and four Gigabit SFP ports.

 

J9773A Specification

J9773A Specifications

Type Aruba 2530-24G-PoE+ Switch
System specifications
Ports
  • · 24 RJ-45 autosensing 10/100/1000 PoE+ ports (IEEE 802.3 Type 10BASE-T, IEEE 802.3u Type 100BASE-TX, IEEE 802.3ab Type 1000BASE-T, IEEE 802.3at PoE+); Media Type: Auto-MDIX; Duplex: 10BASE-T/100BASE-TX: half or full; 1000BASE-T: full only
  • · 4 fixed Gigabit Ethernet SFP ports
  • · 1 dual-personality (RJ-45 or USB micro-B) serial console port.
Memory and processor Processor: ARM9E @ 800 MHz, 128 MB flash, 256 MB DDR3 DIMM; packet buffer size: 1.5 MB dynamically allocated.
Mounting Mounts in an EIA-standard 19-inch telco rack or equipment cabinet (rack-mounting kit available); horizontal surface mounting; wall mounting.
Management IMC – Intelligent Management Center; Command-Line Interface (CLI); Web browser; configuration menu; out-of-band management (serial RS-232C or Micro USB);IEEE 802.3 Ethernet MIB; Repeater MIB; Ethernet Interface MIB.
Performance (IPv6 Ready Certified)
1000 Mb latency < 2.3 µs (LIFO 64-byte packets)
100 Mb Latency < 7.4 µs (LIFO 64-byte packets)
Throughput up to 41.6 million pps (64-byte packets)
Switching capacity 56 Gb/s
MAC address table size 16000 entries
Physical specifications
Dimensions (W x D x H) 44.3 x 33.02 x 4.45 cm (17.44 x 13.00 x 1.75 in) (1U height)
Weight 3.95 kg (8.7 lb)
Electrical specifications
Maximum heat dissipation 135 BTU/hr (142.42 kJ/hr), (switch only: 135 BTU/hr; combined switch + max. PoE devices: 843 BTU/hr)
Voltage 100 – 127 / 200 – 240 V ac
Current 3.2/1.6 A
Idle power1 25.2 W
Maximum power rating2 247 W
PoE power 195 W
Frequency 50/60 Hz
NOTE: 1: Idle power is the actual power consumption of the device with no ports connected.

2: Maximum power rating and maximum heat dissipation are the worst-case theoretical maximum numbers provided for planning the infrastructure with fully loaded PoE (if equipped), 100% traffic, all ports plugged in, and all modules populated. PoE power is the total power budget available to all PoE ports.

Environmental specifications
Operating temperature 0° to 45°C (32° to 113°F)
Operating relative humidity 15% to 95% @ 40°C (104°F), noncondensing
Non-operating/storage temperature -40° to 70°C (-40° to 158°F)
Non-operating/storage relative humidity 15% to 90% @ 65°C (149°F), noncondensing
Altitude Up to 3 km (10,000 ft)
Acoustic Power: 39.6 dB, Pressure: 43.9 dB
Safety agency certifications
Safety UL 60950-1; CAN/CSA 22.2 No. 60950-1; EN 60825; IEC 60950-1; EN 60950-1
NOTE: IEEE 802.3az applies to Gigabit models only; IEEE 802.3at and IEEE 802.3af apply to PoE+ models only. When using SFPs with this product, SFPs with revision “B” or later (product number ends with the letter “B” or later, e.g., J4858B, J4859C) are required.

 

 

HPE 2530 24G PoE+ Switch DataSheet

 

 

Reviews

There are no reviews yet.

Be the first to review “Aruba HPE 2530 24G PoE+ Switch J9773A”

Your email address will not be published. Required fields are marked *

Scroll to Top